Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMESUN ROOF/T-TOP/CONVERTIBLE TOPSUNROOFGENERAL PROCEDURESROOF OPENING PANEL ALIGNMENT
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Roof Opening Panel Alignment
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Roof Opening Panel Alignment
- Open the roof opening panel to the VENT position.
- Loosen the 4 roof opening panel glass screws.
- Close the roof opening panel glass.
- Adjust the roof opening panel glass.
- Open the roof opening panel to the VENT position and tighten the 4 roof opening panel glass screws.
NOTE:
The correct position of the roof opening panel glass to the roof panel should be -1.5 mm to 0 mm (-0.059 to 0 in) at the front edge and 0 mm to 1.5 mm (0 to 0.059 in) at the rear edge of the roof panel.
Make sure the roof opening panel is centered in the roof opening.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.