Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE BASE, 2.3 Z, FWD, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)RESTRAINTSAIR BAG, SRSSUPPLEMENTAL INFLATABLE RESTRAINT SYSTEMREMOVAL AND INSTALLATIONRESTRAINTS CONTROL MODULE (RCM)INSTALLATION
2007 Ford Escape Base, 2.3 Z, FWD, Automatic
Restraints Control Module (RCM): Installation
2007 Ford Escape Base, 2.3 Z, FWD, AutomaticSECTION Installation
- Position the RCM and install the 3 bolts.
- Tighten to 11 Nm (8 lb-ft).
- Connect the small RCM electrical connector.
- Make sure the connector position assurance lever is in the full release position before attempting to connect the large RCM electrical connector.
WARNING:
The tightening torque of the air bag RCM retaining bolts is critical for correct system operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.