Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE 4WD L4-2.3L VIN H HYBRIDREPAIR AND DIAGNOSISRESTRAINTS AND SAFETY SYSTEMSAIR BAG SYSTEMSTESTING AND INSPECTIONPINPOINT TESTSTEST V: LFC 15/DTC C1414 - INCORRECT VEHICLE ID
2007 Ford Escape 4WD L4-2.3L VIN H Hybrid
Test V: LFC 15/DTC C1414 - Incorrect Vehicle ID
2007 Ford Escape 4WD L4-2.3L VIN H HybridSECTION Test V: LFC 15/DTC C1414 - Incorrect Vehicle ID
PINPOINT TEST V: LFC 15/DTC C1414 - INCORRECT VEHICLE ID
Normal Operation
The restraints control module (RCM) monitors the communication condition and circuits of the occupant classification sensor (OCS) system for an embedded vehicle ID. If the RCM detects an unexpected condition or code from the OCS, it will store diagnostic trouble code (DTC) C1414 in memory and flash lamp fault code (LFC) 15 (or higher priority code if one exists) on the air bag indicator. For Hybrid vehicles, the RCM also monitors for a ground circuit on C2041a pin 21.
Possible Causes
An incorrect vehicle identification code can be caused by:
- damaged wiring, terminals or connectors.
- incorrect OCS system for vehicle.
- incorrect RCM for vehicle.
V1:
V2-V5:
V6-V8:
Normal Operation
The restraints control module (RCM) monitors the communication condition and circuits of the occupant classification sensor (OCS) system for an embedded vehicle ID. If the RCM detects an unexpected condition or code from the OCS, it will store diagnostic trouble code (DTC) C1414 in memory and flash lamp fault code (LFC) 15 (or higher priority code if one exists) on the air bag indicator. For Hybrid vehicles, the RCM also monitors for a ground circuit on C2041a pin 21.
Possible Causes
An incorrect vehicle identification code can be caused by:
- damaged wiring, terminals or connectors.
- incorrect OCS system for vehicle.
- incorrect RCM for vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.