Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007ESCAPE 4WD L4-2.3L VIN H HYBRIDREPAIR AND DIAGNOSISMAINTENANCESERVICE INTERVALSNORMAL SERVICE90000 MI OR 144000 KM
2007 Ford Escape 4WD L4-2.3L VIN H Hybrid
90000 MI or 144000 KM
2007 Ford Escape 4WD L4-2.3L VIN H HybridSECTION 90000 MI or 144000 KM
Lubricate
Steering
Lubricate steering linkage, if equipped with zerk fittings.
Inspect
Vehicle
Recommened Multi-Point Inspection
Filters
Inspect rear battery A/C filter, install a new filter if necessary.
Replace
Oil Filter, Engine
Fluid Filter - A/T
Replace the remote filter element on vehicles equipped with the Torqshift transmission.
Engine Oil
Air Filter Element
Replace engine air filter.
Rotate
Tires
Rotate tires, inspect for wear and measure tread depth.
Steering
Lubricate steering linkage, if equipped with zerk fittings.
Inspect
Vehicle
Recommened Multi-Point Inspection
Filters
Inspect rear battery A/C filter, install a new filter if necessary.
Replace
Oil Filter, Engine
Fluid Filter - A/T
Replace the remote filter element on vehicles equipped with the Torqshift transmission.
Engine Oil
Air Filter Element
Replace engine air filter.
Rotate
Tires
Rotate tires, inspect for wear and measure tread depth.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.