Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Edge SE, AWDFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Air cleaner assembly bracket bolt | 11 | 8 | - |
| Air cleaner outlet pipe clamp | 5 | - | 44 |
| Battery tray bolts | 10 | - | 89 |
| Catalytic converter nuts | 40 | 30 | - |
| Catalytic converter support bracket bolts | 20 | 15 | - |
| Catalytic converter support bracket nut | 40 | 30 | - |
| Catalytic converter support bracket/intermediate shaft bearing support bracket bolt. | 55 | 41 | - |
| Cover assembly-to-transaxle case boltsa | - | - | - |
| Differential carrier baffle bolts | 12 | 9 | - |
| Driveshaft bolts | 70 | 52 | - |
| Exhaust Y-pipe assembly clamp | 40 | 30 | - |
| Exhaust Y-pipe assembly nuts | 40 | 30 | - |
| Fluid filler tube nut | 11 | 8 | - |
| Fluid reservoir bolts | 12 | 9 | - |
| Fluid pump-to-torque converter housing bolts | 12 | 9 | - |
| Halfshaft nuts | 350 | 258 | - |
| Intermediate shaft bearing support bracket bolts, all wheel drive (AWD) vehicles | 23 | 17 | - |
| Intermediate shaft bearing support bracket bolts, front wheel drive (FWD) vehicles | 55 | 41 | - |
| Line pressure tap plug | 9 | - | 80 |
| Lower bumper-to-subframe support nuts | 10 | - | 89 |
| Main control cover boltsa | - | - | - |
| Manual lever nut | 18 | 13 | - |
| Output shaft speed (OSS) sensor bolt | 12 | 9 | - |
| Park pawl retainer bolts | 12 | 9 | - |
| Power steering tube retaining bracket bolt | 5 | - | 44 |
| Power transfer unit (PTU)-to-transaxle bolts | 90 | 66 | - |
| PTU support bracket bolts | 70 | 52 | - |
| Roll restrictor bolts | 90 | 66 | - |
| Roll restrictor heat shield nut | 11 | 8 | - |
| Selector lever cable bracket bolts | 12 | 9 | - |
| Shim gauge bolts | 24 | 18 | - |
| Solenoid body boltsa | - | - | - |
| Stabilizer bar bracket bolts | 48 | 35 | - |
| Starter battery terminal | 12 | 9 | - |
| Starter bolts | 26 | 19 | - |
| Starter solenoid terminal | 6 | - | 53 |
| Stator support feed tube bolts (hex head) | 12 | 9 | - |
| Stator support feed tube bolts (Torx® head) | 7 | - | 62 |
| Stator support-to-torque converter housing boltsa | - | - | - |
| Steering knuckle-to-ball joint pinch bolts | 55 | 41 | - |
| Steering rack bolts | 107 | 79 | - |
| Steering rack heat shield bolts | 6 | - | 53 |
| Subframe nuts | 150 | 111 | - |
| Subframe support bracket bolts | 103 | 76 | - |
| Sway bar link nuts | 55 | 41 | - |
| Thermal bypass valve nuts | 9 | - | 80 |
| Torque converter bolts | 55 | 41 | - |
| Torque converter housing-to-transaxle case boltsa | - | - | - |
| Torque converter housing bolts | 48 | 35 | - |
| Transaxle support insulator bolts | 55 | 41 | - |
| Transaxle support insulator bracket nuts | 63 | 46 | - |
| Transaxle support insulator through bolt | 175 | 129 | - |
| Transmission fluid cooler tube-to-thermal bypass valve fittings | 25 | 18 | - |
| Transmission fluid cooler tube-to-transaxle case bolts | 9 | - | 80 |
| Transmission fluid drain plug | 9 | - | 80 |
| Turbine shaft speed (TSS) sensor bolt | 12 | 9 | - |
| Valve body assembly bolts | 12 | 9 | - |
| Valve body-to-case boltsa | - | - | - |
a Refer to the appropriate procedures.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.