Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Edge SE, AWDFACTORY OEM SERVICE PROCEDURE
Line Pressure Chart
LINE PRESSURE CHART
| Gear | Line |
|---|---|
| Pressures at Idle a | |
| P | 372-413 kPa (54-60 psi) |
| R | 689-724 kPa (100-105 psi) |
| N | 372-413 kPa (54-60 psi) |
| D | 579-600 kPa (84-87 psi) |
| L | 579-600 kPa (84-87 psi) |
| Pressure at Wide Open Throttle (WOT) Stall a | |
| P | 372-413 kPa (54-60 psi) |
| R | 1,724-2,068 kPa (250-300 psi) |
| N | 372-413 kPa (54-60 psi) |
| D | 1,655-1,724 kPa (240-250 psi) |
| L | 1,655-1,724 kPa (240-250 psi) |
a All pressures are approximate.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.