Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Edge SE, AWDFACTORY OEM SERVICE PROCEDURE
Automatic Transmission: Disassembly: Transaxle
Special Tools
| Illustration | Tool Name | Tool Number |
|---|---|---|
| Holding Fixture | 307-580 | |
| Forward Clutch Spring Compressor | 307-574 (includes 307-574/1 and 307-574/2) | |
| Compressor, Forward/Overdrive Spring | 307-584 (includes 307-584/1 and 307-584/2) | |
| Remover/Installer, Front Wheel Hub | 204-069 (T81P-1104-C) | |
| Remover, Transfer Gear Bearing Race | 307-577 | |
| Remover, Differential Gear Bearing Race | 307-586 |
- Using the special tool, install the transaxle onto the bench.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.