Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Ford Edge SE, AWDFACTORY OEM SERVICE PROCEDURE

Main Control Assembly: Assembly

CAUTION: Do not stone or polish any valves. If the valves do not move freely during assembly, install a new valve body.

Install the valve body valves, springs, and retaining clips in the main control valve body and lower valve body. See the main control valve body assembly illustration for valve and spring locations.
Install the manual valve in the valve body.

Fig 1: Identifying Manual Valve From Valve Body

Courtesy of FORD MOTOR CO.

Position a new lower valve body separator plate and gasket on the main control valve body.

Fig 2: Identifying Lower Valve Body Separator Plate & Gasket

Courtesy of FORD MOTOR CO.

Position the lower valve body on the main control valve body.

Fig 3: Identifying Lower Valve Body Assembly

Courtesy of FORD MOTOR CO.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.