2007 Ford Edge SE, AWDFACTORY OEM SERVICE PROCEDURE

Output State Control (OSC) Mode: Procedure

NOTE: Retrieve Continuous Codes and carry out a KOEO and KOER On-Demand Self Test before using any OSC. Any DTCs related to the transmission range (TR) sensor, the output shaft speed (OSS) sensor or the turbine shaft speed (TSS) sensor must be fixed or the PCM will not allow the OSC to operate.

OSC is used to test various transaxle components and functions when the vehicle is either in the service bay or being driven on the road. Specific vehicle conditions are required for OSC to control each specific function or component. The following will describe which transaxle functions and components OSC may control and the specific vehicle conditions necessary for its operation.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.