Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007EDGE FWD V6-3.5LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYCRANKSHAFT GEAR/SPROCKET
2007 Ford Edge FWD V6-3.5L
Crankshaft Gear/Sprocket
2007 Ford Edge FWD V6-3.5LSECTION Crankshaft Gear/Sprocket
Crankshaft Pulley Bolt
Discard the bolt.
First pass 120 Nm (89 ft. lbs).
Second pass Loosen one full turn
Third pass 50 Nm (37 ft. lbs).
Final pass Tighten 90°
Discard the bolt.
First pass 120 Nm (89 ft. lbs).
Second pass Loosen one full turn
Third pass 50 Nm (37 ft. lbs).
Final pass Tighten 90°
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.