Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Tests AU: The Power Seat Is Inoperative/Does Not Operate Correctly - Second Row, Right, Folding
2007 Ford Edge FWD V6-3.5LSECTION Tests AU: The Power Seat Is Inoperative/Does Not Operate Correctly - Second Row, Right, Folding
PINPOINT TEST AU: THE POWER SEAT IS INOPERATIVE/DOES NOT OPERATE CORRECTLY - SECOND ROW, RIGHT, FOLDING
Normal operation
The second row power-fold seat relay is provided voltage on the coil side from the smart power distribution box (SPDJB), on pin 85, circuit CPS 48 (BU), for 30 minutes after turning the vehicle off, when the transmission selector is in PARK, and the liftgate, or liftgate glass is open. Ground for the coil side of the relay is on pin 86, circuit GD120 (BK/GN). The second row power-fold seat relay switched side is supplied battery voltage from battery junction box (BJB) fuse 27 (10A) on relay pin 30, is hot at all times. Pushing the double-throw switch to the appropriate rear seat release actuator, left or right, will provide power and allow folding of that seat. If the relay is disabled after 30 minutes, it can be enabled by opening any door, pressing the unlock key on the key fob, pressing any keyless keypad button or turning the ignition key.
Possible Causes
An inoperative second row power-fold seat can be caused by:
- wiring, terminals or connectors.
- a faulted power-fold seat switch.
- a faulted right power-fold seat actuator.
- a faulted power-fold relay.
AU1-AU3:
AU3-AU5:
Normal operation
The second row power-fold seat relay is provided voltage on the coil side from the smart power distribution box (SPDJB), on pin 85, circuit CPS 48 (BU), for 30 minutes after turning the vehicle off, when the transmission selector is in PARK, and the liftgate, or liftgate glass is open. Ground for the coil side of the relay is on pin 86, circuit GD120 (BK/GN). The second row power-fold seat relay switched side is supplied battery voltage from battery junction box (BJB) fuse 27 (10A) on relay pin 30, is hot at all times. Pushing the double-throw switch to the appropriate rear seat release actuator, left or right, will provide power and allow folding of that seat. If the relay is disabled after 30 minutes, it can be enabled by opening any door, pressing the unlock key on the key fob, pressing any keyless keypad button or turning the ignition key.
Possible Causes
An inoperative second row power-fold seat can be caused by:
- wiring, terminals or connectors.
- a faulted power-fold seat switch.
- a faulted right power-fold seat actuator.
- a faulted power-fold relay.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.