Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSFORD2007EDGE FWD V6-3.5LREPAIR AND DIAGNOSISBODY AND FRAMESEATSPOWER SEAT SWITCHSERVICE AND REPAIRSEAT CONTROL SWITCH-FRONT
2007 Ford Edge FWD V6-3.5L
Seat Control Switch-Front
2007 Ford Edge FWD V6-3.5LSECTION Seat Control Switch-Front
Seat Control Switch - Front
Special Tool(s):
Removal and Installation
Warning: To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.
NOTE: The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
ALL SEATS
1. If possible, position the seat all the way up and center the seat in the front door opening.
2. Depower the supplemental restraint system (SRS). Refer to Service and Repair
3. Separate the safety belt retractor belt anchor from the seat in the following sequence.
1. Carefully pull up and out to remove the safety belt retractor belt anchor nut cover from the cushion side shield.
2. Remove the safety belt anchor nut. To install, tighten to 47 Nm (35 lb-ft).
3. Separate the safety belt retractor belt anchor from the seat.
4. Remove the seat control switch in the following sequence.
1. Pull out and remove the seat control switch knob(s).
2. If equipped with manual recline, release the clip and remove the manual recline handle.
3. If equipped with manual lumbar, pull and remove the manual lumbar handle.
4. Remove the cushion side shield screw(s).
5. Slide the cushion side shield up in the rear to release the retailer.
6. Slide the cushion side shield forward to disengage the retainer.
7. Release the cushion side shield clips and separate the seat control switch.
8. Disconnect the seat control switch electrical connector and remove the switch.
5. To install, reverse the removal procedure.
6. Repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time. Refer to Service and Repair
PASSENGER SEAT
7. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS. Refer to Seat Occupant Classification Module - Air Bag
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.