Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2007CROWN VICTORIA LX, 4.6 WREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - POWERTRAIN DTC CHARTS AND DESCRIPTIONS (EXCEPT DIESEL & HYBRID)DTC DIAGNOSISP0602 - POWERTRAIN CONTROL MODULE (PCM) PROGRAMMING ERROR
2007 Ford Crown Victoria LX, 4.6 W
P0602 - Powertrain Control Module (Pcm) Programming Error
2007 Ford Crown Victoria LX, 4.6 WSECTION P0602 - Powertrain Control Module (Pcm) Programming Error
P0602 - POWERTRAIN CONTROL MODULE (PCM) PROGRAMMING ERROR
| Description: | This DTC indicates a programming error within the vehicle ID (VID) block. | |||
| Possible Causes: |
|
|||
| Diagnostic Aids: | Using the scan tool, reprogram the VID block. If the PCM does not allow reprogramming of the VID block, reflashing of the PCM is required. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | The VID block must be programmed. Refer toFLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) . | |||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.