SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSIONDISASSEMBLY AND ASSEMBLY OF SUBASSEMBLIESMAIN CONTROL VALVE BODYASSEMBLY
2005 Ford Taurus SEL, 4D Sedan

Main Control Valve Body: Assembly

2005 Ford Taurus SEL, 4D SedanSECTION Assembly
  1. If removed, position a new valve body sleeve with the notch and the hole in the sleeve with the valve body passage hole aligned.
    Fig 1: Aligning Sleeve Hole With Valve Body Passage Hole
    G03957060Courtesy of FORD MOTOR CO.
  2. Using the special tool and a suitable press, install the new sleeve in the valve body.
    Fig 2: Installing Sleeve In Valve Body
    G03957059Courtesy of FORD MOTOR CO.
  3. Verify that the valve body sleeve extends 5.5 mm (0.21 in) above the valve body surface.
    Fig 3: Identifying Valve Body Sleeve
    G03957062Courtesy of FORD MOTOR CO.
  4. Verify that the holes in the valve body sleeve align with the passage hole in the valve body.
    Fig 4: Aligning Passage Hole In Valve Body
    G03957063Courtesy of FORD MOTOR CO.
    5. CAUTION: Do not stone or polish any of the valves. If the valves do not move freely during assembly, replacement of the valve body is necessary.
  5. Install the valves and springs.
  6. Install the check balls.
    CHECK BALL IDENTIFICATION CHART

    Item Check Ball Identification
    1 B4
    2 B1
    3 B3
    4 B2
    Fig 5: Installing Check Balls
    G03957055Courtesy of FORD MOTOR CO.
  7. Install the relief valves and springs.
    1. Install the modulator check valve and springs.
    2. Install the manual low relief valve and drain back spring.
    3. Install the manual low relief valve and cooler bypass spring.
    Fig 6: Installing Relief Valves And Spring
    G03957056Courtesy of FORD MOTOR CO.
  8. Install new filters.
    1. Install a new solenoid regulator filter.
    2. Install a new torque converter clutch filter.
    Fig 7: Installing Filters
    G03957057Courtesy of FORD MOTOR CO.
    9. CAUTION: Verify correct alignment of the relief and check valves to the separator plate before tightening the bolts. If the relief and check valves are incorrectly installed, the transaxle will not operate correctly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.