Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Disassembly and Assembly
2005 Ford Taurus SEL, 4D SedanSECTION Disassembly and Assembly
WARNING: This page is about a different variant/trim than selected.
- Using the special tool, compress the valve spring (6513) and remove the valve spring retainers (6518).
- Remove the valve springs (6513).
- For component tests, refer to ENGINE SYSTEM-GENERAL INFORMATION .
- Remove the valve seal (6A517).
- Remove the valve (6507/6505).
- For component tests, refer to ENGINE SYSTEM-GENERAL INFORMATION .
- To assemble, reverse the disassembly procedure.
- Lubricate the valve stem and the valve seal with clean engine oil.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.