SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 932 (SEAT SYSTEM)REMOVAL AND INSTALLATIONSEAT - FRONTINSTALLATION
2005 Ford Taurus SEL, 4D Sedan

Seat - Front: Installation

2005 Ford Taurus SEL, 4D SedanSECTION Installation
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the front seat and install the 2 front seat track-to-floor bolts.
    • Tighten to 48 Nm (35 lb-ft).
  2. Connect the seat harness electrical connector(s).
  3. Repower the supplemental restraint system (SRS). For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM article.
  4. Move the seat to the most forward position.
  5. Install the 2 front seat track-to-floor nuts.
    • Tighten to 40 Nm (30 lb-ft).
  6. Install the 2 front seat track-to-floor nut covers.
  7. Make sure the safety belts and buckles are accessible to the occupants after installation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.