Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 929 (BUMPER SYSTEM)REMOVAL AND INSTALLATIONBUMPER - EXPLODED VIEW, REAR
2005 Ford Taurus SEL, 4D Sedan
Bumper - Exploded View, Rear
2005 Ford Taurus SEL, 4D SedanSECTION Bumper - Exploded View, Rear
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Part Number | Description |
|---|---|---|
| 1 | W706607 | Rear bumper cover-to-splash shield bolt (2 required) |
| 2 | W708530-S | Rear bumper cover center pin-type retainers (2 required) |
| 3 | W706713-S | Rear bumper cover outer pin-type retainers (2 required) |
| 4 | W706607-S900 | Rear bumper cover screws (6 required) |
| 5 | - | Liftgate alignment bumper bolts (2 required) |
| 6 | - | Liftgate alignment bumpers |
| 7 | 17775 | Rear bumper cover |
| 8 | W706713-S | Rear bumper isolator rivets (3 required) |
| 9 | 17E899 | Rear bumper isolator |
| 10 | W707144-S | Rear bumper nuts (4 required) |
| 11 | 17D942 | Rear bumper |
- For additional information, refer to the following procedures.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.