Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 670 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS AND DESCRIPTIONS (EXCEPT DIESEL & HYBRID))DTC DIAGNOSISP2270 - O2 SENSOR SIGNAL STUCK LEAN - BANK 1, SENSOR 2
2005 Ford Taurus SEL, 4D Sedan
P2270 - O2 Sensor Signal Stuck Lean - Bank 1, Sensor 2
2005 Ford Taurus SEL, 4D SedanSECTION P2270 - O2 Sensor Signal Stuck Lean - Bank 1, Sensor 2
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
P2270 - O2 SENSOR SIGNAL STUCK LEAN - BANK 1, SENSOR 2
| Description: | The downstream heated oxygen sensor (HO2S) is forced rich and lean and monitored by the powertrain control module (PCM). The test fails if the PCM does not detect the output of the HO2S in a calibrated amount of time. | |||
| Possible Causes: |
|
|||
| Diagnostic Aids: | ||||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | - | refer to PINPOINT TEST H . | refer to PINPOINT TEST H . | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.