Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection and Verification
2005 Ford Taurus SEL, 4D SedanSECTION Inspection and Verification
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the customer concern by operating the system.
- Visually inspect for obvious signs of mechanical or electrical damage.
- If an obvious cause for an observed or reported concern is found, correct the cause before proceeding to the next step.
- If the concern is not visually evident, verify the symptom. GO to SYMPTOM CHART .VISUAL INSPECTION CHART
Mechanical Electrical - Transmission shift cable
- Manual control lever
- Transmission control module out of adjustment (6-speed transaxle)
- Fuse
- Connections
- Wiring harness
- Brake pedal position (BPP) switch
- Shift lock actuator
DIAGNOSTIC TROUBLE CODE (DTC) CHART
| DTC | Component | Description | Condition | Symptom | Action |
|---|---|---|---|---|---|
| B2572 | Brake Shift Interlock | Brake Shift Interlock Output Circuit Failure | The associated circuitry connected to the smart junction box (SJB) or fuse, or the SJB itself may have an issue causing a brake shift interlock concern. | Brake shift interlock is inoperative or does not operate correctly. | GO to PINPOINT TEST A . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.