Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 621 (MANUAL TRANSAXLE/TRANSMISSION)REMOVALTRANSAXLE

2005 Ford Taurus SEL, 4D Sedan

Section 621 (Manual Transaxle/Transmission): Removal: Transaxle

2005 Ford Taurus SEL, 4D SedanSECTION Transaxle

WARNING: This page is about a different car, the 2006 Mercury Milan and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

SPECIAL TOOL(S)

Courtesy of FORD MOTOR CO.	Three-Bar Engine Support Kit 303-F072
Courtesy of FORD MOTOR CO.	Hi-Lift Jack 014-00942

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove battery and the battery tray. For additional information, refer to BATTERY, MOUNTING AND CABLES .
Remove the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING - 2.3L .

CAUTION: Carefully disconnect the spring clip.

Disconnect the gearshift cables from the shift mechanism.
- Pull the spring clip out of the groove. Lift upward to rotate the clip 90 degrees.
  
  Fig 1: Pulling Spring Clip Out Of Groove (1 Of 2)
  Courtesy of FORD MOTOR CO.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.