Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 563 (ENGINE IGNITION)DESCRIPTION AND OPERATIONENGINE IGNITION
2005 Ford Taurus SEL, 4D Sedan
Engine Ignition
2005 Ford Taurus SEL, 4D SedanSECTION Engine Ignition
WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
The electronic ignition (El) system for the 3.0L Duratec engine consists of the following components:
- Crankshaft position (CKP) sensor
- Camshaft position (CMP) sensor
- 6 ignition coil-on-plugs
- 6 spark plugs
The CKP sensor:
- is a variable reluctance sensor.
- is mounted in the front cover.
- is triggered by a 36-minus-l tooth trigger wheel located behind the front cover.
- provides base timing and crankshaft speed (rpm) to the powertrain control module (PCM). For additional information, refer to ELECTRONIC ENGINE CONTROLS .
The CMP sensor:
- is a variable reluctance sensor.
- is mounted in the front cover.
- is triggered by the high point mark on the LH exhaust camshaft.
- provides camshaft rotational location information to the PCM. For additional information, refer to ELECTRONIC ENGINE CONTROLS .
The 6 ignition coil-on-plugs:
- are connected directly to each spark plug.
- change low voltage signals from the PCM to high voltage pulses.
- supply the high voltage pulses to the spark plugs.
The 6 spark plugs:
- change high voltage pulses into a spark which ignites the fuel and air mixture.
- originally equipped on the vehicle have a platinum-enhanced active electrode for long life.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.