SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 500 (INFORMATION CENTER)GENERAL PROCEDURESCOMPASS ZONE ADJUSTMENT
2005 Ford Taurus SEL, 4D Sedan

Compass Zone Adjustment

2005 Ford Taurus SEL, 4D SedanSECTION Compass Zone Adjustment
WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Compass Calibration Zones 

Fig 1: Compass Calibration Zone Map
G03965509Courtesy of FORD MOTOR CO.
  1. The factory zone setting is set to Zone 8. Check the map to verify the correct compass zone setting for your geographic location.
  2. Turn the ignition switch to the RUN position.
  3. From the info menu, press and hold the SETUP and RESET buttons simultaneously until the message center shows the current zone setting.
  4. Release the SETUP and RESET buttons. Press the SETUP button until the correct zone setting is displayed.
  5. To exit the zone setting mode, and to lock in the change, press and release the RESET button.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.