SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 410 (SEAT SYSTEM)DIAGNOSIS AND TESTINGSEATSSYMPTOM CHART
2005 Ford Taurus SEL, 4D Sedan

Symptom Chart

2005 Ford Taurus SEL, 4D SedanSECTION Symptom Chart
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM CHART

Condition Possible Sources Action
  • The power seat is inoperative
  • Smart junction box (SJB) fuse 9 (30A).
  • Circuitry.
  • Seat control switch.
  • The power seat moves but is noisy
  • Obstruction or foreign
  • Seat track.
  • The power seat moves but is loose
  • Fastening hardware.
  • Seat track.
  • The power seat does not make full travel
  • Seat track obstructed.
  • Seat track.
  • The power seat does not move horizontally/vertically
  • Circuitry.
  • Seat control switch.
  • The heated seat is inoperative
  • Fuse.
  • Circuitry.
  • Heated seat relay.
  • Heated seat switch.
  • Seat does not heat but the heated seat indicator illuminates when pressed
  • Circuitry.
  • Heated seat switch.
  • Cushion heated seat element and bi-metallic thermostat.
  • Backrest heated seat element.
  • Seat does heat but the heated seat indicator does not illuminate when pressed
  • Circuitry.
  • Heated seat switch.
  • CHECK circuit 57 (BK) for an open. If no problem is found, INSTALL a new heated seat switch.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.