Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 373 (MULTIFUNCTION ELECTRONIC MODULES SYSTEM)REMOVAL AND INSTALLATIONSMART JUNCTION BOX (SJB)REMOVAL
2005 Ford Taurus SEL, 4D Sedan
Smart Junction Box (SJB): Removal
2005 Ford Taurus SEL, 4D SedanSECTION Removal
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
The steps included in the SJB removal and installation procedure are critical to restoring the SJB and tire pressure monitoring systems to normal operation. A new SJB is delivered in manufacturing mode with 6 preset diagnostic trouble codes (DTCs) related to the tire pressure monitoring system (TPMS). The presence of these DTCs requires the installation procedures be followed in order to clear the DTCs and enable normal SJB operations.
- Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Remove the floor console SJB cover.
- Remove the transmission selector lever bezel from the floor console finish panel.
- Apply the parking brake.
- Remove the parking brake lever boot from the floor console finish panel.
- Remove the floor console finish panel.
- Remove the SJB screw.
- Disconnect the electrical connectors and remove the SJB.
NOTE:
Prior to removal of the SJB, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed. For additional information, refer to
MODULE CONFIGURATION
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.