Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 345 (AUTOMATIC TRANSMISSION - CD4E)DIAGNOSIS AND TESTINGPINPOINT TESTS - NON OSC EQUIPPED VEHICLENOTES
2005 Ford Taurus SEL, 4D Sedan
Pinpoint Tests - Non OSC Equipped Vehicle: Notes
2005 Ford Taurus SEL, 4D SedanSECTION Notes
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
SOLENOID OPERATION TABLE
| Transaxle Range Selector Lever Position | PCM Commanded Gear | SSA | SSB | 3-2T/CCS | TCC | ||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| P/N | - | OFF | ON | ON | OFF | ||||||
| R | - | OFF | ON/OFF | ON | (1) | ||||||
| (D) | 1 | ON | ON | ON | (1) | ||||||
| 2 | OFF | ON | ON | (2) | |||||||
| 3 | OFF | OFF | ON | (2) | |||||||
| 4 | ON | OFF | ON | (1) | |||||||
| D OD cancelled | 1 | ON | ON | ON | (1) | ||||||
| 2 | OFF | ON | OFF | (2) | |||||||
| 3 | OFF | OFF | OFF | (2) | |||||||
| 2 | 2 | OFF | ON | OFF | (2) | ||||||
| 2(3) | 3 | OFF | OFF | OFF | (2) | ||||||
| 1 | 1 | ON | ON | OFF | (1) | ||||||
| l(3) | 2 | OFF | ON | OFF | (2) | ||||||
| l(3) | 3 | OFF | OFF | OFF | (2) | ||||||
|
|||||||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.