SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 344 (ENGINE SYSTEM-GENERAL INFORMATION)GENERAL PROCEDURESVALVE GUIDE INNER DIAMETER
2005 Ford Taurus SEL, 4D Sedan

Valve Guide Inner Diameter

2005 Ford Taurus SEL, 4D SedanSECTION Valve Guide Inner Diameter
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the inner diameter of the valve guides in two directions where indicated.
    2. Fig 1: Measuring Valve Guide Inner Diameter
    G04617854Courtesy of FORD MOTOR CO.
  2. If the valve guide is not within specifications, install a new cylinder head assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.