Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 331 (WHEELS & TIRES)DIAGNOSIS AND TESTINGTIRE PRESSURE MONITORING SYSTEMTPMS INDICATOR FLASHES
2005 Ford Taurus SEL, 4D Sedan
TPMS Indicator Flashes
2005 Ford Taurus SEL, 4D SedanSECTION TPMS Indicator Flashes
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
The TPMS indicator flashes for 70 seconds and then remains ON solid when the ignition key is turned to the ON position for the following conditions:
- Tire Pressure Sensor Fault - If equipped, the message center will display TIRE SENSOR FAULT when a tire pressure sensor is malfunctioning. GO to SYMPTOM CHART .
- No communication with the SJB (TPMS is integral to the SJB) - The TPMS indicator is illuminated when the instrument cluster has received no signals from the SJB for more than 5 seconds. If equipped, the message center displays TIRE MONITOR FAULT. GO to SYMPTOM CHART .
- Tire Pressure Monitor Fault - If equipped, the message center will display TIRE MONITOR FAULT when the tire pressure monitoring system is malfunctioning or communication with the instrument cluster has been lost. GO to SYMPTOM CHART .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.