Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 303 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REMOVAL AND INSTALLATIONDRIVER AIR BAG MODULEINSTALLATION
2005 Ford Taurus SEL, 4D Sedan
Driver Air Bag Module: Installation
2005 Ford Taurus SEL, 4D SedanSECTION Installation
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the driver air bag module.
- Connect the horn electrical connector.
- Connect the driver air bag module electrical connectors as noted during removal.
- Install the driver air bag module electrical wiring into the driver air bag wiring clip.
CAUTION: The clockspring electrical connectors are unique and cannot be reversed when connected to the driver air bag module. Match the electrical connector key to the keyway in the driver air bag module. Do not force the electrical connectors into the driver air bag module.
NOTE:
With the driver air bag module held as close to the steering wheel as possible, take up the slack in the wiring by gently tucking any excess length into the pocket at the bottom of the steering wheel before rocking the driver air bag module into place.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.