Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 261 (ELECTRONIC ENGINE CONTROLS)SPECIFICATIONSTORQUE SPECIFICATIONS
2005 Ford Taurus SEL, 4D Sedan
Torque Specifications
2005 Ford Taurus SEL, 4D SedanSECTION Torque Specifications
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Camshaft position (CMP) sensor bolt | 10 | - | 89 |
| Crankshaft position (CKP) sensor | 10 | - | 89 |
| A/C compressor bolts | 25 | 18 | - |
| CKP sensor wiring harness clip nut | 9 | - | 80 |
| Powertrain control module (PCM) retaining bolt | 10 | - | 89 |
| Throttle position (TP) sensor screws | 3 | - | 27 |
| Mass air flow (MAF) sensor retaining screws | 6 | - | 53 |
| Heated oxygen sensor (HO2S) | 41 | 30 | - |
| Catalyst monitor sensor | 41 | 30 | - |
| Fuel rail pressure and temperature sensor bolts | 5 | - | 44 |
| Cylinder head temperature (CHT) sensor | 26 | 19 | - |
| Lower generator bolt | 25 | 18 | - |
| Generator bracket bolt | 10 | - | 89 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.