SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 252 (ENGINE SYSTEM)IN-VEHICLE REPAIRENGINE MOUNT - RHREMOVAL AND INSTALLATION
2005 Ford Taurus SEL, 4D Sedan

Removal and Installation

2005 Ford Taurus SEL, 4D SedanSECTION Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: If equipped with fire suppression system, depower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the generator. For additional information, refer to GENERATOR AND REGULATOR .
  3. Install the special tool.
    Fig 1: Installing Special Tool
    G04583574Courtesy of FORD MOTOR CO.
  4. Install the special tool.
    Fig 2: Installing Special Tool
    G04583575Courtesy of FORD MOTOR CO.
    5. NOTE: RH shown, LH similar.
  5. Remove the RH and LH lower engine mount nuts.
    • To install, tighten to 90 Nm (66 lb-ft).
  6. Using the special tool, raise the engine.
    Fig 3: Raising Engine
    G04583576Courtesy of FORD MOTOR CO.
  7. Remove the 3 RH engine mount bolts.
    • To install, tighten to 70 Nm (52 lb-ft).
  8. Remove the RH engine mount.
    9. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  9. To install, reverse the removal procedure. If equipped with fire suppression system, repower the system
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.