SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 163 (REAR DRIVE HALFSHAFTS)SPECIFICATIONSTORQUE SPECIFICATIONS
2005 Ford Taurus SEL, 4D Sedan

Torque Specifications

2005 Ford Taurus SEL, 4D SedanSECTION Torque Specifications
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS

Description Nm lb-ft
Brake caliper anchor bolts 110 81
Brake disc retainer 21 16
Rear axle wheel end nut (4WD)(1) 350 258
Rear brake anti-lock sensor bolt 14 10
Hub bolts 120 89
(1) Install and tighten the new rear axle wheel end nut to specification in a continuous rotation. Stopping the rotation during installation will cause the nylon lock to set incorrectly. This will cause incorrect torque readings while tightening the rear axle wheel end nut, and lead to bearing failure. Install a new rear axle wheel end nut every time after loosening or not installing the rear axle wheel end nut to specification in a continuous rotation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.