Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 160 (ANTI-LOCK BRAKE SYSTEM)DIAGNOSIS AND TESTINGANTI-LOCK CONTROLPINPOINT TEST A: NO COMMUNICATION WITH THE ANTI-LOCK BRAKE SYSTEM (ABS) MODULETESTING
2005 Ford Taurus SEL, 4D Sedan
Pinpoint Test A: No Communication With the Anti-lock Brake System (ABS) Module: Testing
2005 Ford Taurus SEL, 4D SedanSECTION Testing
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- A1 CHECK CIRCUIT 532 (OG/YE) FOR AN OPEN
- Key in OFF position.
- Disconnect: ABS module C135.
- Key in ON position.
- Measure the voltage between the ABS module C135-32, circuit 532 (OG/YE), harness side and ground.
- Is the voltage greater than 10 volts?
- Yes : GO to A2.
- No : REPAIR the circuit. TEST the system for normal operation.
- A2 CHECK CIRCUIT 1203 (BK/LB) FOR AN OPEN
- Key in OFF position.
- Measure the resistance between the ABS module C135-38, circuit 1203 (BK/LB), harness side and ground.
- Is the resistance less than 5 ohms?
- Yes : REFER to MODULE COMMUNICATIONS NETWORK to continue diagnosis of the communication network.
- No : REPAIR the circuit. TEST the system for normal operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.