Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC U2100: Initial Configuration Not Complete: Action
Action
ATTEMPT to CONFIGURE the PSCM using programmable module installation (PMI) refer to MODULE CONFIGURATION . Otherwise, CONFIGURE the PSCM using vehicle as-built data. Clear the DTC and repeat the self-test. If the DTC returns install a new EPAS gear referring to POWER STEERING SYSTEM , Removal and Installation .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.