Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1487 (ENGINE CONTROLS - POWERTRAIN DTC CHARTS AND DESCRIPTIONS (HYBRID))DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONSDTC P1A10: HYBRID POWERTRAIN CONTROL MODULE - BATTERY DISABLED
2005 Ford Taurus SEL, 4D Sedan
DTC P1A10: Hybrid Powertrain Control Module - Battery Disabled
2005 Ford Taurus SEL, 4D SedanSECTION DTC P1A10: Hybrid Powertrain Control Module - Battery Disabled
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, 2011 Ford Fusion, 2010 Mercury Milan, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
P1A10 - HYBRID POWERTRAIN CONTROL MODULE - BATTERY DISABLED
| Description: | This informational DTC sets when the high voltage traction battery initiates a vehicle shutdown. | ||
| Possible Causes: | |||
| Diagnostic Aids: | Check for the presence of BECM DTCs. Refer to the CHARGING SYSTEM - HIGH VOLTAGE TRACTION BATTERY -- FUSION, MILAN & MKZ (HYBRID) | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC in table | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.