Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 144 (AUTOMATIC TRANSMISSION - 6 SPEED)SPECIFICATIONSGENERAL SPECIFICATIONS CHART
2005 Ford Taurus SEL, 4D Sedan
General Specifications Chart
2005 Ford Taurus SEL, 4D SedanSECTION General Specifications Chart
WARNING: This page is about a different car, the 2005 Mercury Montego and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS CHART
| Item | Specification |
|---|---|
| Fluid | |
|
CAUTION:
MERCON®, MERCON®V, MERCON®SP, Motorcraft Premium Automatic Transmission Fluid and Motorcraft Continuously Variable Chain Type Transmission Fluid are not interchangeable transmission fluids. The use of any fluid other than what is recommended for this transmission will cause transmission damage. Refer to the Owner/Schedule Maintenance Guide to determine the correct service interval for the specific vehicle.
|
|
|
CAUTION:
Do not use water-based cleaners to clean or flush the cooler tubes or transmission damage will occur. Mineral spirits can be used to clean the cooler tubes, providing the cooler tubes are flushed with clean automatic transmission fluid and blown dry with shop air. Use only clean automatic transmission fluid designated for the transmission and torque converter being serviced.
|
|
| Motorcraft Premium Automatic Transmission Fluid XT-8-QAW (US); CXT-8-LAW12 (Canada) | WSS-M2C924-A |
| Fluid Capacities | |
| All | 7.0L (7.4 quarts) |
| Fluid Filter | |
| Internal to the transmission | - |
| Lubricants | |
| Multi-Purpose Grease XG-4 and/or XL-5 | ESB-M1C93-B |
| Threadlock and Sealer TA-25 | WSK-M2G351-A5 |
| Torque Converter End Play | |
| New or rebuilt | 0.355--1.04 mm (0.014--0.041 inch) |
| Used | 0.355--1.87 mm (0.014--0.074 inch) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.