Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1388 (ELECTRICAL COMPASS - ELECTRONIC COMPASS)GENERAL PROCEDURESCOMPASS CALIBRATION
2005 Ford Taurus SEL, 4D Sedan
Compass Calibration
2005 Ford Taurus SEL, 4D SedanSECTION Compass Calibration
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This procedure is only applicable to vehicles without navigation. For vehicles with navigation, there is no compass calibration.
- Start the vehicle.
NOTE:
For optimum calibration, drive to an open, level location away from large metallic objects or structures such as bridges, steel buildings, etc. Switch off all non-essential electrical accessories (heated rear window, heater fan, A/C, map lamps, and wipers) and make sure all doors are closed.
NOTE:
The vehicle remains in the CAL mode until the compass has been successfully calibrated.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.