Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
With Navigation
The compass display is incorporated into the Front Display Interface Module (FDIM). Refer to FRONT DISPLAY INTERFACE MODULE (FDIM) .
The compass signal originates from the Global Positioning System (GPS) antenna. No calibration or zone adjustment is available, as the compass heading is based on the GPS signal. Refer to INFORMATION AND ENTERTAINMENT SYSTEM .
The vehicle heading is displayed as a 1 or 2 character display located in the upper RH side of the FDIM and indicates the current direction of the vehicle (N, NE, E, SE, S, SW, W, or NW).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.