Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1271 (BUMPER SYSTEM)REMOVAL AND INSTALLATIONBUMPER - EXPLODED VIEW, FRONTMKZ
2005 Ford Taurus SEL, 4D Sedan
Bumper - Exploded View, Front: MKZ
2005 Ford Taurus SEL, 4D SedanSECTION MKZ
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
ITEM DESCRIPTION TABLE
| Item | Part Number | Description |
|---|---|---|
| 1 | W711676 | Upper radiator grille bolt (2 required) |
| 2 | N807389 | Upper radiator grille pin-type retainer (2 required) |
| 3 | W709976 | Lower air deflector screw (4 required) |
| 4 | N807389 | Fender splash shield pin-type retainer (4 required) |
| 5 | 17C831 | Front bumper cover |
| 6 | N807389 | Lower air deflector pin-type retainer (4 required) |
| 7 | 8327 | Lower air deflector |
| 8 | W709976 | Fender splash shield screw (6 required) |
| 9 | N808650 | Bumper cover mounting bracket rear bolt |
| 10 | 17D958 LH/17D959 RH | Bumper cover mounting bracket |
| 11 | W711676 | Bumper cover mounting bracket front bolt |
- For additional information, refer to the appropriate procedure(s).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.