Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1244 (MANUAL TRANSAXLE)DISASSEMBLY AND ASSEMBLY OF SUBASSEMBLIESDIFFERENTIALSPECIAL TOOL(S)
2005 Ford Taurus SEL, 4D Sedan
Special Tool(s)
2005 Ford Taurus SEL, 4D SedanSECTION Special Tool(s)
WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL SPECIFICATION TABLE
| Adapter Set, Step Plate 205-DS011 (D80L-630-A) or equivalent | |
| Bearing Puller 205-D064 (D84L-1123-A) or equivalent | |
| Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-A) | |
| Installer, Differential Bearing Cup 308-162 (T88C-77000-EH) | |
| Push/Puller Set 205-DS023 (D80L-927-A) or equivalent |
PART NUMBER REFERENCE TABLE
| Item | Part Number | Description |
|---|---|---|
| 1 | 4221 | Differential bearings |
| 2 | 17285 | Speedometer drive gear |
| 3 | 4241 | Differential pinion shaft lock pin |
| 4 | 4026 | Differential |
| 5 | 4228 | Differential side gear thrust washers |
| 6 | 4236 | Differential side gears |
| 7 | 4230 | Differential pinion gear thrust washers |
| 8 | 4215 | Differential pinion gears |
| 9 | 4211 | Differential pinion shaft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.