Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1227 (BODY PANEL SYSTEM - FRONT END BODY PANELS)SPECIFICATIONSTORQUE SPECIFICATIONS TABLE
2005 Ford Taurus SEL, 4D Sedan
Torque Specifications Table
2005 Ford Taurus SEL, 4D SedanSECTION Torque Specifications Table
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS TABLE
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| A/C line retaining bolt | 6 | -- | 53 |
| Fender lower bolts | 9 | - | 80 |
| Fender rear lower bolt | 9 | - | 80 |
| Fender rear upper bolt | 9 | - | 80 |
| Fender support brace bolts | 9 | - | 80 |
| Fender upper bolts | 9 | - | 80 |
| Fender upper rear inner bolt | 5 | - | 44 |
| Hood hinge-to-body bolts | 22 | 16 | - |
| Hood hinge-to-hood bolts | 22 | 16 | - |
| Hood latch bolts | 12 | - | 106 |
| Hood striker bolts | 12 | - | 106 |
| Radiator grille support bolts | 12 | - | 106 |
| Windshield washer reservoir retaining bolt | 7 | - | 62 |
| Wiper mounting arm and pivot shaft assembly bolts | 5 | - | 44 |
| Wiper pivot arm nuts | 20 | - | 177 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.