Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1195 (CHARGING SYSTEM)DIAGNOSIS AND TESTINGDIAGNOSTIC TROUBLE CODE (DTC) TABLE
2005 Ford Taurus SEL, 4D Sedan
Diagnostic Trouble Code (DTC) Table
2005 Ford Taurus SEL, 4D SedanSECTION Diagnostic Trouble Code (DTC) Table
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC TROUBLE CODE (DTC) TABLE
| DTCs | Description | Source | Action |
|---|---|---|---|
| P0563 | System Voltage High | PCM | Go To PINPOINT TEST A . |
| P0563 | System Voltage High | Various Modules | Go To PINPOINT TEST A |
| P0620 | Generator Control Circuit | PCM | Go To PINPOINT TEST C . |
| P0625 | Generator Field Terminal Circuit Low | PCM | Go To PINPOINT TEST D . |
| P0626 | Generator Field Terminal Circuit High | PCM | Go To PINPOINT TEST D . |
| P065B | Generator Control Circuit Range/Performance | PCM | Go To PINPOINT TEST E . |
| All other DTCs | - | Various Modules | REFER to the Master DTC Table in DIAGNOSTIC TROUBLE CODE (DTC) TABLE or the INTRODUCTION - GASOLINE MODELS /INTRODUCTION -- HYBRID . If directed to this article from another article, GO to SYMPTOM TABLE . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.