Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1137 (CLIMATE CONTROL)REMOVAL AND INSTALLATIONREGISTER - CENTERREMOVAL
2005 Ford Taurus SEL, 4D Sedan
Register - Center: Removal
2005 Ford Taurus SEL, 4D SedanSECTION Removal
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the instrument cluster finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
- Remove the center finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
- Drill out the heat stakes on the register and remove the register.
- Remove the louver assembly.
- Use a screwdriver to pry out the louver assembly.
NOTE:
Use care not to damage the center finish panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.