Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Disable Using the Ignition Lock Cylinder
2005 Ford Taurus SEL, 4D SedanSECTION Disable Using the Ignition Lock Cylinder
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The auto lock feature is not available on vehicles equipped with manual transmissions.
- Close all the doors.
- Confirm that the ignition switch is in the OFF position.
- Turn the ignition switch from OFF to ON.
- Press the door lock control switch UNLOCK button 3 times.
- Turn the ignition switch from ON to OFF.
- Press the door lock control switch UNLOCK button 3 times.
- Turn the ignition switch from OFF to ON.
- Press the door lock control switch UNLOCK button, then the LOCK button.
- Verify the horn chirps 1 time. The auto lock/relock feature has been disabled.
- Turn the ignition switch to the OFF position to exit the enable/disable mode.
NOTE:
Steps 4 through 8 must be carried out within 30 seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.