Hydraulic Control Unit (HCU): Notes

2005 Ford Taurus SEL, 4D SedanSECTION Notes
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
Material

Item Specification
High Performance DOT 3 Motor Vehicle Brake Fluid
PM-1-C (US); CPM-1-C (Canada)
WSS-M6C62-A
Fig 1: Hydraulic Control Unit (HCU) Components With Torque Specifications
GF0042318Courtesy of FORD MOTOR CO.
Item Part Number Description
1 W712119 Hydraulic control unit (HCU) bracket-to-frame bolts (3 required)
2 2C215 HCU
3 - Master cylinder secondary brake tube fitting (part of 2268)
4 - Master cylinder primary brake tube fitting (part of 2268)
5 - LH front brake tube fitting (part of 2264)
6 - RH front brake tube fitting (part of 2263)
7 - Rear brake tube fittings (part of 2267)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.