Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1068 (ANTI-LOCK BRAKE SYSTEM)DIAGNOSTIC TESTSANTI-LOCK CONTROL - HYBRIDSYMPTOM CHART

2005 Ford Taurus SEL, 4D Sedan

Symptom Chart

2005 Ford Taurus SEL, 4D SedanSECTION Symptom Chart

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Symptom Chart

Condition	Possible Sources	Action
No communication with the ABS module	Circuitry ABS module	REFER to MODULE COMMUNICATIONS NETWORK article to diagnose the no communication problem.
The red brake warning indicator and the yellow ABS warning indicator are both illuminated	DTCs present in the ABS module	REFER to ABS Module DTC Chart .
The red brake warning indicator is illuminated and the yellow ABS warning indicator is not illuminated	Circuitry Parking brake Brake fluid level sensor Instrument cluster ABS module	REFER to BRAKE SYSTEM - GENERAL INFORMATION article to diagnose the red brake warning indicator.
The ABS warning indicator is never/always on	Circuit Instrument cluster ABS module	REFER to INSTRUMENT CLUSTER (IC), MESSAGE CENTER, AND WARNING CHIMES article to diagnose the instrument cluster.
ABS false activation at low speeds or near the end of stopping the vehicle.	ABS wheel speed sensor tone ring	INSPECT the tone rings, INSTALL new as necessary.
Spongy brake pedal with no warning indicator	Air in brake hydraulic system Base brakes	REFER to Diagnosis and Testing in BRAKE SYSTEM - GENERAL INFORMATION article.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.