Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1002 (WIPER SYSTEM AND WASHER SYSTEM)GENERAL PROCEDURESWASHER HOSE REPAIR
2005 Ford Taurus SEL, 4D Sedan
Washer Hose Repair
2005 Ford Taurus SEL, 4D SedanSECTION Washer Hose Repair
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This procedure may be carried out on rubber hoses only. If a plastic washer hose is leaking, a new washer hose must be installed.
- Locate and verify the leaking washer hose.
- Cut the hose cleanly and remove the damaged portion of the washer hose.
- Install a windshield washer hose adapter between the cut ends of the hose.
- Install a segment of 6.4 mm (0.25 in) ID black rubber hose over the ends of the washer hose and clamp both ends of the rubber hose using spring clamps.
NOTE:
In difficult cases, clamping may be required.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.