DTC P0605: Powertrain Control Module (PCM) Read Only Memory (ROM) Error

2005 Ford Taurus SEL, 4D SedanSECTION DTC P0605: Powertrain Control Module (PCM) Read Only Memory (ROM) Error
P0605 - POWERTRAIN CONTROL MODULE (PCM) READ ONLY MEMORY (ROM) ERROR

Description:  The PCM ROM has been corrupted.
Possible Causes: 
  • An attempt was made to change the calibration
  • Module programming error
  • Damaged PCM
Diagnostic Aids:  Reprogram or update the calibration.
Reprogram the VID block (use as built data).
Check for other DTCs or drive symptoms for further action.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All Make sure to check for aftermarket performance products before installing a new powertrain control module (PCM). If it is necessary to install a new PCM, refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.