Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISENGINE MECHANICALMECHANICALENGINE - 3.0L (4V)SPECIFICATIONSTORQUE SPECIFICATIONS
2005 Ford Taurus SEL, 4D Sedan
Torque Specifications
2005 Ford Taurus SEL, 4D SedanSECTION Torque Specifications
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in | ||
|---|---|---|---|---|---|
| A/C compressor bolts | 25 | 18 | - | ||
| A/C compressor bracket bolts(1) | - | - | - | ||
| A/C line nut | 8 | - | 71 | ||
| A/C-to-coolant pump bracket bolts | 25 | 18 | - | ||
| Accessory drive belt tensioner bolt | 25 | 18 | - | ||
| Camshaft cap bolts | 10 | - | 89 | ||
| Camshaft position (CMP) sensor bolt | 10 | - | 89 | ||
| Camshaft oil seal retainer | 10 | - | 89 | ||
| Crankcase cover bolts | 10 | - | 89 | ||
| Crankshaft damper bolt(1) | - | - | - | ||
| Crankshaft position sensor (CKP) bolt | 10 | - | 89 | ||
| Crankshaft pulley(1) | - | - | - | ||
| Crankshaft pulley bracket nuts | 25 | 18 | - | ||
| Cylinder head bolts(1) | - | - | - | ||
| Exhaust gas recirculation (EGR) tube nuts | 40 | 30 | - | ||
| EGR valve bolts | 25 | 18 | - | ||
| EGR valve nuts | 10 | - | 89 | ||
| Engine front cover bolts and studs(1) | - | - | - | ||
| Engine cooling fan | 10 | - | 89 | ||
| Engine mount bolts | 90 | 66 | - | ||
| Engine roll restrictor bolts | 40 | 30 | - | ||
| Engine roll restrictor bracket bolts | 63 | 46 | - | ||
| EGR vacuum regulator tube nuts | 6 | - | 53 | ||
| Exhaust bracket nut | 40 | 30 | - | ||
| Flexplate bolts | 80 | 59 | - | ||
| Ball joint nuts | 80 | 59 | - | ||
| Front splash shield bolts | 7 | - | 62 | ||
| Fuel charging harness nut | 3 | - | 27 | ||
| Fuel supply manifold bolts | 10 | - | 89 | ||
| Generator bolts and studs | 25 | 18 | - | ||
| Ground strap bolt | 15 | 11 | - | ||
| Halfshaft-to-wheel hub nuts | 258 | 191 | - | ||
| Heater hose bracket nuts | 10 | - | 89 | ||
| Ignition coil-on-plug bolts | 6 | - | 53 | ||
| Knock sensor (KS) bolt | 18 | 13 | - | ||
| LH engine support insulator bolts | 70 | 52 | - | ||
| LH engine support insulator nut | 90 | 66 | - | ||
| LH exhaust manifold nuts | 20 | 15 | - | ||
| Lower cylinder block bolts and studs(1) | - | - | - | ||
| Lower intake manifold bolts | 10 | - | 89 | ||
| Oil filter | 16 | 12 | - | ||
| Oil level indicator and tube stud | 10 | - | 89 | ||
| Oil pan baffle nuts(1) | - | - | - | ||
| Oil pan bolts and studs | 25 | 18 | - | ||
| Oil pan drain plug | 27 | 20 | - | ||
| Oil pan-to-transaxle bolts | 40 | 30 | - | ||
| Oil pressure sensor | 14 | 10 | - | ||
| Oil pump bolts | 10 | - | 89 | ||
| Oil pump screen and pick up tube bolts(1) | - | - | - | ||
| Outer tie rod end nuts | 55 | 41 | - | ||
| Power steering pump bolts | 25 | 18 | - | ||
| Power steering pressure line bracket nut | 10 | - | 89 | ||
| Power steering pressure line nut | 37 | 27 | - | ||
| Powertrain control module (PCM) electrical connector bolt | 6 | - | 53 | ||
| Radiator support bracket bolt | 10 | - | 89 | ||
| RH engine support insulator nut | 90 | 66 | - | ||
| RH engine support insulator through bolt and nut | 62 | 46 | - | ||
| RH exhaust manifold nuts | 20 | 15 | - | ||
| RH radio ignition interference capacitor nut | 6 | - | 53 | ||
| Shifter cable nut | 17 | 13 | - | ||
| Spark plugs | 15 | 11 | - | ||
| Starter motor ground cable bolt | 25 | 18 | - | ||
| Starter cable positive nut | 12 | 9 | - | ||
| Steering shaft pinch bolt | 24 | 18 | - | ||
| Subframe bolts | 103 | 76 | - | ||
| Sway bar end link nuts | 55 | 41 | - | ||
| Throttle body bolt and stud | 10 | - | 89 | ||
| Timing chain guide bolts | 25 | 18 | - | ||
| Timing chain tensioner bolts | 25 | 18 | - | ||
| Torque converter-to-flexplate nuts | 37 | 27 | - | ||
| Transaxle-to-oil pan bracket bolt | 25 | 18 | - | ||
| Transaxle-to-oil pan bracket nuts | 10 | - | 89 | ||
| Upper intake manifold bolts | 10 | - | 89 | ||
| Valve cover bolts and studs | 10 | - | 89 | ||
| Wire harness nut | 3 | - | 27 | ||
| Y-pipe nuts | 40 | 30 | - | ||
| Y-pipe-to-exhaust manifold nuts | 40 | 30 | - | ||
|
|||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.