Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLBRAKE SYSTEM-GENERAL INFORMATIONDIAGNOSIS AND TESTINGBRAKE SYSTEMBRAKE CALIPER GUIDE PINS
2005 Ford Taurus SEL, 4D Sedan
Brake Caliper Guide Pins
2005 Ford Taurus SEL, 4D SedanSECTION Brake Caliper Guide Pins
CAUTION:
Do not use power tools for caliper guide pin bore cleaning.
The guide pins should slide with a reasonable amount of hand force. If the brake pads show taper wear or the guide pins are difficult to move, carry out the following steps.
NOTE:
If a guide pin kit is not available, install a new caliper assembly.
- Disassemble the guide pins. For additional information, refer to FRONT DISC BRAKE for front disc brakes or REAR DISC BRAKE for rear disc brakes.
- Use a wire brush, rolled-up sandpaper, or emery cloth to remove all corrosion and foreign material from the caliper guide pin bores. Clean any remaining debris from the bores with brake parts cleaner and compressed air.
- Install new brake pads if the lining is not within specifications. For additional information, refer to FRONT DISC BRAKE for front disc brakes or REAR DISC BRAKE for rear disc brakes.
- Assemble the caliper guide pins using new caliper seals, boots, and guide pins. Use an ample amount of grease to lubricate the bores and guide pins.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.