Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2005TAURUS SEL, 4D SEDANREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTACCESSORIES CONTROL SYSTEMSCOMPONENT TESTINGCOMPONENT TESTINGSEAT ADJUST SWITCHCOMPONENT TESTING PROCEDURE
2005 Ford Taurus SEL, 4D Sedan
Component Testing Procedure
2005 Ford Taurus SEL, 4D SedanSECTION Component Testing Procedure
SEAT ADJUST SWITCH - COMPONENT TESTING
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Forward/Rearward circuit | 7 and 5 | Forward | Closed circuit |
| Rearward | Open circuit | ||
| 7 and 3 | Forward | Open circuit | |
| Rearward | Closed circuit | ||
| 5 and 1 | Rest | Closed circuit | |
| 3 and 1 | |||
| Front up/down circuit | 7 and 2 | Up | Closed circuit |
| Down | Open circuit | ||
| 7 and 8 | Up | Open circuit | |
| Down | Closed circuit | ||
| 2 and 1 | Rest | Closed circuit | |
| 8 and 1 | |||
| Rear up/down circuit | 7 and 6 | Up | Closed circuit |
| Down | Open circuit | ||
| 7 and 4 | Up | Open circuit | |
| Down | Closed circuit | ||
| 4 and 1 | Rest | Closed circuit | |
| 6 and 1 | |||
| Up/Down Circuit | 7 and 2 | Up | Closed circuit |
| 7 and 6 | Down | Open circuit | |
| 7 and 8 | Up | Open circuit | |
| 7 and 4 | Down | Closed circuit | |
| 2 and 1 | Rest | Closed circuit | |
| 8 and 1 | |||
| 4 and 1 | |||
| 6 and 1 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.